When decorating, installing the fan coil unit thermostat is also an important step, because the fan coil unit thermostat determines the temperature in the room and is also a link that we should pay attention to, so we will also pay attention to it, but at the same time, in order to make the living room beautiful, we will try every means to reduce the routing of the fan coil unit thermostats, and we can install the fan coil unit thermostat in a suitable position for people to use. Therefore, friends who have no contact with the installation of fan coil thermostat can read the following articles. It should be helpful to everyone.
Introduction of Fan Coil Temperature Controller:
Fan coil unit thermostat is suitable for temperature control in industrial, commercial and family rooms. By comparing the indoor temperature with the set temperature, the fan coil unit and electric valve or electric air valve at the end of the central air conditioning system are controlled to achieve the purposes of adjusting the indoor temperature, improving the environmental comfort and saving energy.
Installation and operation steps of fan coil unit thermostats:
1. Insert a slotted screwdriver into the small card seat on the side of the fan coil unit thermostat, gently pry open the bottom plate (do not use excessive force or the shell card seat will be broken) to separate the fan coil thermostats panel from the bottom plate, then fix the bottom plate at the desired location with the screws provided, and then fasten the fan coil thermostat panel to the bottom plate.
2. The fan coil unit thermostats wiring must be correctly wired according to the electrical wiring diagram. Do not allow impurities such as water and mud to enter the fan coil unit thermostats, otherwise the device will be damaged.
3. Fan coil unit temperature controller shall be installed on the wall surface with free flow of ambient air, 1.2m high from the ground, and it is a place with stable temperature and not close to the entrance or air conditioning device. The installation position shall ensure that it is not affected by other heat sources and sunlight, airflow of doors and windows or temperature of external wall.
